ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Master Cylinder – Remove and Install (12 343 0) > < Plate – Rear Brake Carrier – Remove and install (12 313 0)

Transit 1995 (08.1994-07.2000)

Brake Pedal – Remove and Install (12 333 0) Transit 1995 (08/1994-07/2000)
Print Print
Removal and Installation
Remove
1. Remove the clevis pin and spring clip from the brake pedal servo operating push rod.

2. Remove the stop lamp switch.
1. Disconnect the switch multiplug.
2. Twist the switch through 90° and remove the switch.

3. Remove the brake and clutch pedal cross‐shaft clips from the pedal bracket.

4. Remove the brake pedal.
1. Push the cross shaft towards the clutch pedal sufficient to remove the brake pedal.
2. Remove the brake pedal.

5. Remove the pedal bushes and spring.
1. Remove the pedal bushes.
2. Remove the spring.
Install
6. Refit the components in the reverse order.

7. Refit and adjust the stop lamp switch.
1. Slide in the switch until the plunger is compressed.
2. Twist the switch clockwise to lock in position.
3. Reconnect the multiplug.

Master Cylinder – Remove and Install (12 343 0) > < Plate – Rear Brake Carrier – Remove and install (12 313 0)