ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Wheel Bearings – Adjust (14 403 0) > < Stub Axle – Remove and Install (14 363 0)

Transit 1995 (08.1994-07.2000)

Hub Assembly - Front - Renew (Hub Assembly Removed) (14 371 6)Transit 1995 (08/1994-07/2000)
Print Print
Removal and Installation
Special Tools

21-051Remover, radial seal

14-052Installer, grease seal

14-010Installer, bearing cup
Remove
1. Mark the hub and disc to assist in realignment.

2. Remove the hub from the disc.

3. Remove the grease seal.
4. Remove the inner and outer bearing cones.

CAUTION:

Take care not to raise burrs in the hub as this may prevent the new cups from seating properly.

NOTE:

Tap alternately at diametrically opposite points of the cups, do not allow the cups to tilt in the hub.
5. Remove the inner and outer bearing cups.
6. Clean the mating faces of the hub and the disc.
Install
7. Refit the hub to the disc.
• Align the marks.

CAUTION:

Ensure the cups fit tightly against their abutment faces.

CAUTION:

The cup and cone assemblies must be from the same manufacturer.

CAUTION:

It is essential that the grease and bearings do not get contaminated.
8. Refit the inner and outer bearing cups.

9. Pack the cone and roller bearings with grease.
10. Refit the bearing cones.
11. Clean the grease seal housing and apply a coating of sealant to the periphery of the seal.

12. Refit the grease seal.
   Remove any surplus sealant.
13. Fill between the seal journal lips and coat the face lip with grease.

Wheel Bearings – Adjust (14 403 0) > < Stub Axle – Remove and Install (14 363 0)