Note the position of the spacers and paper washers. Make sure these are correctly positioned for installation.
1. Remove the vehicle jacking kit (back row seat only).
1. Release the retaining straps.
2. Remove the jack assembly.
2. Remove the floor mounted seat belt stalk.
Remove the Torx retaining screw.
3. Detach the dual seat assembly.
Remove the seven Torx retaining screws.
4. Detach the upper seat belt anchor.
1. Remove the upper anchor cover.
2. Remove the Torx retaining screw.
5. Detach the lower seat belt anchor.
Remove the Torx retaining screw.
6. Remove the seat belt assembly.
Remove the Torx retaining screw.
Install
CAUTION:
When installing the seat belt make sure the webbing is correctly routed and not twisted. Make sure the seat belt operates correctly without restriction.