ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Remote Control Assembly - Front Door Lock - Remove And Install (41 353 0) > < Handle - Door Exterior - Remove And Install (41 333 0)

Transit 1995 (08.1994-07.2000)

Barrel - Door Lock - Remove And Install (41 336 0)Transit 1995 (08/1994-07/2000)
Print Print
Removal and Installation
Remove
1. Fully close the door window.

CAUTION:

Disconnect the battery negative lead.
2. Remove the door trim panel (refer to Operation No. 42 705 0).

CAUTION:

Do not touch the adhesive surface as re‐bonding will be impaired. Do not attempt to peel the water shield from the door without cutting the Butyl bead using a plastic knife.
3. Peel back the door insulation.

4. Remove the door remote control handle.

WARNING:

Support the window to stop it dropping.
5. Drill out the lock shield panel fixing rivets.

6. Cut the PU adhesive (fixing the lock shield to the outer door skin).

7. Remove the door window guide runner.
   Remove one screw and pull down to displace the locating clip on the top of the guide.

8. Remove the three lock fixing screws and detach the lock.
9. Disconnect the lock motor multiplug (where applicable).

10. Detach the barrel operating rod and remove the lock assembly.
   Open the clip and push out the rod.

11. Disconnect the barrel set/reset switch (where fitted).

12. Remove the barrel.
   Remove the barrel retaining clip.
Install
13. Refit the components in reverse order.

Remote Control Assembly - Front Door Lock - Remove And Install (41 353 0) > < Handle - Door Exterior - Remove And Install (41 333 0)