Ford Workshop Service and Repair Manuals

Aligner, Oil Pump

303-705 (21-256)

1. Remove the oil pan.
   For additional information, refer to: Oil Pan (303-01A Engine - 2.4L Duratorq-Di (Puma) Diesel/2.4L Duratorq-TDCi (Puma) Diesel, In-vehicle Repair) /
   Oil Pan (303-01 Engine - 2.0L Duratorq-Di/TDDi (Puma) Diesel/2.0L Duratorq-TDCi (Puma) Diesel, In-vehicle Repair).
   

2. 

   NOTE:The profile of the special tool must be in contact with the oil pump sprocket.
   Install the special tool to the engine block and finger tighten the two bolts.
   • Push the special tool against the oil pump sprocket.
   • Tighten the two bolts.

3. Remove the oil pick up pipe.

4. Remove the oil pump retaining bolts.

5. 

   NOTE:On engines equipped with hydraulic chain tensioner, engine oil will be expelled when the chain is pulled down.
   Remove the oil pump.
   • Pull down on the oil pump chain to release the chain from the sprocket.

1. 

   NOTE:Do not fully tighten the oil pump retaining bolts at this stage.
   Install the oil pump.
   • Install the chain onto the oil pump sprocket.
   • Install the oil pump retaining bolts finger tight.

2. 

   NOTE:The profile of the special tool must be in contact with the oil pump sprocket.
   Push the oil pump forward so that the sprocket is in contact with the special tool.
   • Tighten the oil pump retaining bolts.

3. Remove the special tool.

4. Install the oil pick up pipe.

5. Install the oil pan.
   For additional information, refer to: Oil Pan (303-01A Engine - 2.4L Duratorq-Di (Puma) Diesel/2.4L Duratorq-TDCi (Puma) Diesel, In-vehicle Repair) /
   Oil Pan (303-01 Engine - 2.0L Duratorq-Di/TDDi (Puma) Diesel/2.0L Duratorq-TDCi (Puma) Diesel, In-vehicle Repair).