Transit Connect L4-2.0L (2010)
6. Dry the carpet and other interior trim as necessary.
Sealing Pollen Filter Case Base
1. Check for water leaking into the foot well through the floor vents. If there is evidence of water leaking through the floor vents and blower motor case,
then the pollen filter case base gasket needs to be sealed.
2. Remove upper and lower cowl grill panels, to gain access to the pollen filter. Refer to WSM, Section 501-2 Front End Body Panels.
3. Remove pollen filter case.
4. Apply Motorcraft(R) Seam Sealer on case gasket. (Figure 9)
5. Install pollen filter case and cowl grills. Ensure that the lower cowl grill fully seats on the seal, under the hood.
6. Dry the carpet and other interior trim as necessary
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.
OPERATION
DESCRIPTION
TIME
110310A
2010 Transit Connect:
0.3 Hr.
Inspect For Trapped Lamp
Wiring Or Partial Installed
Grommet And Repair As
Necessary, And Perform
Leak Test Can Be Claimed