Transit Connect L4-2.0L (2010)
Brake Master Cylinder: Service and Repair
Brake Fluid Reservoir
Brake Fluid Reservoir
Removal and Installation
WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that
has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of
serious personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In
the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data
Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
NOTICE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or
plastic surface, immediately wash the surface with water.
NOTE: The brake fluid remote reservoir and brake fluid reservoir can be serviced separately.
1. Disconnect the electrical connector from the brake fluid remote reservoir filler cap.
2. Remove the battery tray. For additional information, refer to Battery.
3. Remove the battery ground cable bolt and position the cable aside.
-
To install, tighten to 10 Nm (89 lb-in).
