Transit Connect L4-2.0L (2010)
Water Pump: Service and Repair
Coolant Pump
Removal and Installation
1. Drain the cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding See: Cooling System/Service and
Repair/Cooling System Draining, Filling and Bleeding.
2. Loosen the 3 coolant pump pulley bolts.
-
To install, tighten to 20 Nm (177 lb-in).
3. Remove the accessory drive belt. For additional information, refer to Drive Belts, Mounts, Brackets and Accessories.
4. Remove the 3 coolant pump pulley bolts and the pulley.
5. NOTICE: Make sure the coolant pump is correctly seated to the engine block before installing and tightening the fasteners, or damage to
the coolant pump may occur.
Remove the 3 coolant pump bolts and the coolant pump.
-
To install, tighten to 10 Nm (89 lb-in).
6. NOTE: Install a new coolant pump O-ring seal and lubricate with clean engine coolant.
To install, reverse the removal procedure.