Transit Connect L4-2.0L (2010)
6. Pull the heater blower wiring away from the IP bracket and secure to the large bundle of wire (Figures 2 and 3)
7. Tighten tie strap and verify that the heater wiring is sufficiently spaced away from the IP bracket (Figure 4)
8. Install selector trim panel.
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.
OPERATION
DESCRIPTION
TIME
091906A
2010 Transit Connect:
0.2 Hr.
Inspect And Reroute Wire
Harness Following Service
Procedure (Do Not Use
With Any Other Labor
Operations)
