Transit Connect L4-2.0L (2010)
10. Remove the compressor-to-condenser discharge line bracket nut.
-
Discard the O-ring seal and gasket seal.
11. Remove the A/C compressor suction fitting nut and disconnect the fitting.
-
Discard the O-ring seal and gasket seal.
-
To install, tighten to 15 Nm (133 lb-in).
12. Remove the A/C compressor discharge fitting nut and disconnect the fitting.
-
Discard the O-ring seal and gasket seal.
-
To install, tighten to 15 Nm (133 lb-in).
13. Remove the condenser inlet fitting nut and disconnect the fitting.
-
Discard the O-ring seal.
-
To install, tighten to 9 Nm (80 lb-in).
14. Remove the compressor-to-condenser discharge line.
15. To install, reverse the removal procedure.
-
Install new gasket seals and O-ring seals.
-
Add the correct amount of clean PAG oil to the refrigerant system.
16. Evacuate, leak test and charge the refrigerant system.
