Transit Connect L4-2.0L (2010)
Installation
WARNING: Make sure the front passenger seat repair is complete, the seat and all attached components (head restraint, seat side shield, etc.)
are correctly assembled, and the seat is correctly installed to the vehicle before carrying out the System Reset. Failure to follow these
instructions may result in incorrect operation of the occupant classification sensor (OCS) system and increases the risk of serious personal
injury or death in a crash.
1. WARNING: Install a new occupant classification sensor (OCS) system service kit as a complete assembly. Never install only part of the
kit components. Failure to follow this instruction may result in incorrect operation of the OCS system and increases the risk of serious
personal injury or death in a crash.
Install the OCS bladder and foam.
-
Route the OCS system components and seat wiring through the opening in the suspension spring.
-
Position the OCS bladder to the cushion half pan and install the 2 pin-type retainers.
2. Bend the locking tab back on the pressure sensor bracket and install the pressure sensor onto the bracket making sure the locking tab is completely
engaged.
-
Check the pressure sensor bracket mounting for tightness. If the bracket is loose, install a new rivet to tighten the bracket.
