Transit Connect L4-2.0L (2010)
7. Install the wire harness.
-
Install the wire harness and retainers to the seat track.
-
Attach the seat electrical bulkhead connector to the seat track.
8. Install the cushion cover and all hog rings to the foam pad.
9. Fasten all cushion cover J-clips.
10. Install the inboard side shield and screw.
-
Attach the safety belt buckle wire harness.
11. Install the outboard side shield and screw.
12. If equipped, install the height adjust handle.
13. Install the recliner handle and screw.
14. Install the passenger seat. For additional information, refer to the Removal and Installation portion of Seats.
15. NOTICE: To prevent system failure, it is necessary to carry out the Occupant Classification Sensor (OCS) system reset when a front
passenger seat cushion is disassembled, a new trim cover is installed or an OCS system service kit is installed. A scan tool is used to carry
out the OCS system reset.
Make sure no Occupant Classification System Module (OCSM) DTCs are present. If DTC C1941 has been stored in OCSM memory it will clear
upon a successful system reset. All other OCS system DTCs must be diagnosed and repaired before carrying out the OCS system reset.
16. WARNING: Make sure the front passenger seat repair is complete, the seat and all attached components (head restraint, seat side shield,
etc.) are correctly assembled, and the seat is correctly installed to the vehicle before carrying out the System Reset. Failure to follow these
instructions may result in incorrect operation of the occupant classification sensor (OCS) system and increases the risk of serious
personal injury or death in a crash.
NOTICE: To prevent system failure, the following precautions must be taken before carrying out the Occupant Classification Sensor
(OCS) system reset:
-
Make sure the voltage to the Occupant Classification System Module (OCSM) is above 8 volts and less than 18 volts.
-
Make sure the OCS system is not at a temperature below 6°C (42°F) or above 36°C (97°F) when initiating the OCS system reset. If the
vehicle has been exposed to extreme cold or hot temperatures, the vehicle must be exposed and kept at a temperature within the limits,
6°C to 36°C (42°F to 97°F) for a minimum of 30 minutes.
-
Make sure nothing is present on the passenger seat before carrying out the OCS system reset and nothing is placed on the seat during
the process.
-
Make sure a minimum 8-second time period has passed after cycling the ignition ON before carrying out the OCS system reset.
Carry out the Occupant Classification Sensor (OCS) system reset.
17. If the first system reset attempt was unsuccessful, carry out a thorough inspection of the following and repair any concerns found.
