Transit Connect L4-2.0L (2010)
Suspension Strut / Shock Absorber: Overhaul
Strut and Spring Assembly
Disassembly and Assembly
NOTICE: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result
in major service expense. A new part with the same part number must be installed if installation is necessary. Do not use a new part of lesser
quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of these parts.
1. Remove the strut and spring assembly. For additional information, refer to Strut and Spring Assembly See: Removal and Replacement/Front
Suspension.
2. WARNING: Keep all body parts clear of shock absorbers or strut rods. Shock absorbers or struts can extend unassisted. Failure to
follow this instruction may result in serious personal injury.
Using a suitable coil spring compressor, compress the spring.
3. NOTE: Use the hex-holding feature to prevent the strut rod from rotating while removing the nut.
Remove and discard the strut rod nut.
-
To install, tighten to 58 Nm (43 lb-ft).
4. Remove the upper strut mount, spring upper seat and dust boot.
5. Remove the strut and jounce bumper.
6. Carefully remove the spring from the spring compressor.
7. NOTICE: Make sure the upper strut mount is correctly seated before assembly or damage to the upper mount may occur.
To assemble, reverse the disassembly procedure.
