Transit Connect L4-2.0L (2010)
4. Remove the TSS sensor bolt and sensor.
-
Check the TSS sensor bore.
5. Inspect the O-ring seal for nicks or cuts; install a new O-ring if necessary.
Installation
1. Apply a light coat of clean transmission fluid to the O-ring seal before installation.
2. NOTE: Apply thread sealer to the bolt.
Install the TSS sensor and bolt.
-
Tighten to 10 Nm (89 lb-in).
3. Connect the TSS sensor electrical connector.
4. Install the ACL assembly. For additional information, refer to Fuel Delivery and Air Induction.
5. Install the battery tray. For additional information, refer to Battery.
