Windstar V6-232 3.8L (1995)
Rear Brake Sensors
REMOVAL
1. At rear frame mounting location, disconnect sensor assembly two-pin connector from wiring harness.
2. Separate sensor cable from brake hose clips and feed through frame.
3. Remove rear brake anti-lock sensor retaining bolt from rear wheel disc brake adapter on vehicles with rear disc brakes or from sensor mounting
bracket on vehicles with rear drum brakes.
INSTALLATION
1. To install, reverse Removal procedure. Tighten rear brake anti-lock retaining bolt to 8-10 Nm (71-88 inch lbs.).
