Windstar V6-232 3.8L (1995)
Vehicle Speed Sensor/Transducer - Cruise Control: Service and Repair
SPECIAL SERVICE TOOL(S) REQUIRED
Description ................................................................................................................................................................................................. Tool Number
Exhaust Connector Holder ........................................................................................................................................................................ T94T-6000-AH
REMOVAL
1. Disconnect battery ground cable.
2. Separate upper and lower speedometer cable (if equipped) on LH side of engine compartment below brake master cylinder and unclip speedometer
cable from shift cable and bracket.
3. Raise vehicle on hoist.
4. Disconnect two Heated Oxygen Sensor (HO2S) and two catalyst monitor sensor electrical connectors.
5. Install Exhaust Connector Holder T94T-6000-AH to prevent undue stress on flexible portion of flex pipe. Offset the tool strap bolts so that the two
flex pipe-to-Y-pipe bolts are accessible and tighten tool bolts to 10 Nm (89 lb-in).
CAUTION: Failure to use the Exhaust Connector Holder T94T-6000-AH may result in leakage and reduced life of flex pipe.
6. Remove two flex pipe-to-Y-pipe bolts.
7. Remove Y-pipe-to-transaxle case bracket bolt and nut.
8. Remove four Y-pipe-to-exhaust manifold nuts and remove Y-pipe assembly from vehicle.
9. Carefully remove three pushnuts and transaxle heat shield from transaxle.
WARNING: HEAT SHIELD HAS SHARP EDGES. THE USE OF GLOVES IS RECOMMENDED DURING HEAT SHIELD
REMOVAL AND INSTALLATION TO PREVENT PERSONAL INJURY.
10. Disconnect Vehicle Speed Sensor (VSS) electrical connector.
11. Remove VSS retaining bolt.
12. Remove VSS from fluid cooler tube.