Windstar V6-232 3.8L (1995)
13. Disconnect speedometer cable (if equipped) and remove VSS from transaxle.
INSTALLATION
1. Connect speedometer cable (if equipped) to VSS.
2. Install VSS into fluid cooler tube and secure with VSS retaining bolt. Tighten bolt to 10 Nm (89 lb-in).
3. Connect VSS electrical connector.
4. Install transaxle heat shield and secure with three push nuts.
WARNING: HEAT SHIELD HAS SHARP EDGES. THE USE OF GLOVES IS RECOMMENDED DURING HEAT SHIELD
REMOVAL AND INSTALLATION TO PREVENT PERSONAL INJURY.
5. Install Y-pipe assembly to vehicle and secure with four Y pipe-to-exhaust manifold nuts. Tighten nuts to 34-46 Nm (25-33 lb-ft).
6. Install Y pipe-to-transaxle case bracket bolt and nut. Tighten bolt and nut to 34-46 Nm (25-33 lb-ft).
7. Install two flex pipe-to-Y pipe bolts. Tighten bolts to 34-46 Nm (25-33 lb-ft).
8. Remove Exhaust Connector Holder T94T-6000-AH or equivalent from flex pipe.
9. Connect two heated oxygen sensor (HO2S) and two catalyst monitor sensor electrical connectors.
10. Lower vehicle.
11. Connect upper and lower speedometer cables (if equipped) on LH side of engine compartment below brake master cylinder and attach
speedometer cable to shift cable bracket.
12. Connect battery ground cable.
