Windstar V6-232 3.8L (1995)
Engine Mount: Service and Repair
Removal and Installation
Front
REMOVAL AND INSTALLATION
1. Relieve fuel system pressure.
2. Remove 4 bolts holding A/C compressor to bracket, then position aside without discharging system.
3. Remove mount upper attaching nut.
Fig. 1 Engine Support Fixture
4. Install engine support fixture tool No. 014-00750, lifting bracket set tool No. 014-00794 and adapter kit tool No. 014-00792 or equivalents to
engine.
5. Raise and support vehicle.
6. Remove front lower mount attaching nut.
7. Lower vehicle.
8. Using installed engine lifting equipment, lift engine about one inch.
9. Raise and support vehicle, then remove engine mount.
10. Reverse procedure to install.
Rear
REMOVAL AND INSTALLATION
1. Raise and support vehicle.
2. Loosen RH front and RH rear upper motor mount attaching nuts.
