Windstar V6-232 3.8L (1995)
7.
USING A 15 MM SOCKET, REMOVE (1) BOLT FROM STEADY REST BRACKET. See Figure 2.
8.
USING A 12 INCH EXTENSION AND A 15 MM SOCKET, LOOSEN NUT HOLDING Y-PIPE TO TRANSMISSION CASE.
9.
CAREFULLY REMOVE Y-PIPE FROM VEHICLE TO PREVENT DAMAGE TO HEGO SENSORS OR CONNECTORS.
10.
GENTLY PRY OFF PUSH NUTS HOLDING TRANSMISSION HEAT SHIELD. INSERT A FLAT BLADE SCREWDRIVER BETWEEN
THE PUSH NUT AND THE HEAT SHIELD) GROMMET, AND USE A TWISTING MOTION. See Figure 3.
CAUTION:
DO NOT USE A HAMMER TO START THE PROCESS.
WARNING:
USE SAFETY GLASSES WHEN REMOVING PUSH NUTS.
11.
REMOVE HEAT SHIELD. WARNING: HEAT SHIELD HAS SHARP EDGES. THE USE OF GLOVES IS RECOMMENDED FOR THIS
STEP.
12.
REMOVE OR SLIDE VEHICLE SPEED SENSOR (VSS) HEAT SHIELD TO THE LEFT AND UNPLUG VSS CONNECTOR.
