Windstar V6-232 3.8L (1995)
Main Light Switch: Service and Repair
REMOVAL AND INSTALLATION
1. Disconnect battery ground cable.
2. Remove headlamp switch knob.
3. Remove headlamp switch bezel nut.
4. Remove instrument panel trim.
5. Remove two screws holding switch to panel, then pull switch out of panel and disconnect wiring connector.
6. Reverse procedure to install.
NOTE: Vehicle specific information about operation, stored in PCM using battery backed up memory, may be lost when battery is disconnected.
If this occurs poor engine performance, stalling and other driveability problems may occur. It may be necessary to drive the vehicle for up to 10
miles to allow the PCM to relearn this information.
