Windstar V6-232 3.8L (1995)
2. Raise vehicle.
3. Connect power steering return hose at steering gear.
4. Position new steering shaft heat shield and install tie straps.
5. Connect power steering return hose to power steering oil cooler and tighten clamp to 1.4-2 Nm (13-17 lb-in).
6. Lower vehicle.
NOTE: When the battery has been disconnected and reconnected, some abnormal drive symptoms may occur while the powertrain control module
(PCM) (12A650) relearns its adaptive strategy. The vehicle may need to be driven 10 miles or more to relearn the strategy.
7. Connect battery ground cable.
8. Fill system.
Cooler to Reservoir
Removal
1. Disconnect battery ground cable.
2. Raise vehicle.
3. Remove hose clamp at power steering oil cooler. Disconnect power steering return hose and drain fluid into a suitable container.
