Windstar V6-232 3.8L (1995)
Ignition Cable: Service and Repair
REMOVAL
Spark Plug Wire Remover
1. Remove the spark plug wires from the spark plugs, using the Spark Plug Wire Remover T74P-6666-A. Grasp and twist the boot back and forth on
the plug insulator to free the boot. Use the special tool to pull the boot from the spark plug.
CAUTION: Do not pull on the spark plug wire set directly, as it may become separated from the connector inside the boot.
Removing Ignition Wires At Coil Pack
2. Remove the spark plug wire from the ignition coil pack, squeeze the locking tabs of the coil wire retainer and remove using a twisting and pulling
motion.
CAUTION: Do not pull on the spark plug wire set.
INSTALLATION
CAUTION: Proper installation of spark plug wire set is critical to vehicle operation. If one distributor to spark plug wire is not properly installed
on spark plug or ignition coil, both spark plugs connected to that ignition coil may not fire under load.
1. Whenever a high tension wire is removed for any reason from a spark plug or ignition coil, or a new high tension wire is installed, Silicone
Dielectric Compound D7AZ-19A331-A or equivalent meeting Ford specification ESE-MM1C171-A must be applied to the boot prior to
installation. Using a small, clean tool, coat the entire interior surface of the boot with the compound.
