Windstar V6-232 3.8L (1995)
Fuel Pressure Release: Service and Repair
WARNING: Fuel supply lines on all vehicles equipped with fuel injected engines will remain pressurized after the engine is shut OFF.
FUEL PRESSURE GAUGE METHOD
1. Disconnect negative battery cable from the battery.
2. Remove fuel tank cap.
3. Remove cap from schrader valve on fuel supply manifold, and attach EFI pressure gauge.
4. Direct gauge drain hose into approved fuel storage container, and depress pressure release button on fuel pressure gauge to bleed off fuel pressure.
ALTERNATE METHOD
1. Disconnect electrical connector approximately 254mm (10 inches) behind fuel filter on backside of crossmember.
2. With battery connected, use starter to crank the engine for 15 to 20 seconds to relieve pressure.
