Windstar V6-232 3.8L (1995)
Speed Control Switch Assembly: Testing and Inspection
NOTE: To test speed control actuator switch, perform the following voltage and resistance measurements.
Speed Control Actuator Switch Assembly Voltage Specifications.
For voltage measurements, remove harness connector from speed control servo. Connect negative lead of voltmeter to pin 10 (circuit 676) (PK/O)
of connector. Measure DC or AC voltage of circuits with positive lead of meter.
Speed Control Actuator Switch Assembly Resistor Specifications.
For resistance measurements, remove harness connector at speed control servo. Connect an ohmmeter between the designated circuits, shown in
the chart, with the ignition switch off.
