Windstar V6-232 3.8L (1995)
3.
Remove the connector from the solenoid by firmly grasping the connector and pressing the external detent release (if so equipped) and pulling.
Refer to Figure 1.
CAUTION:
DO NOT PULL ON THE WIRE BECAUSE THIS WILL DAMAGE THE TERMINAL.
4.
DO NOT SAND OR FILE THE TERMINAL. Brush Di-Electric Grease (D7AZ-19A331-A, or equivalent) onto the terminal. Refer to Figure 1.
5.
Using scissors, carefully cut the protective sleeving 4" (100 mm) back from the connector.