Windstar V6-232 3.8L (1995)
Main Control Valve Body Assembly, (Part 2 Of 2)
4. The individual valves and springs are removed by removing retaining clips and bore plugs. Clean valves, springs and main control valve body.
CAUTION: Most valves are aluminum and cannot be removed using a magnet. Remove valves by tapping valve body on palm of hand to slide
valves out of bores. It may be necessary to remove valves and springs using a pick. If It Is necessary to use a pick, use extreme caution to prevent
damaging valves or valve bores.
ASSEMBLY
1. Assemble valves and springs into main control valve body.
Valve Body Check Balls, Relief Valves, And Filter
2. Install check balls, relief valves and filters.
3. Replace valve body separator plate with bonded gasket on main control valve body.
