Windstar V6-232 3.8L (1995)
Front Door Window Regulator: Service and Repair
Manual Window Regulator
REMOVAL
1. Remove the front door trim panel and front door inside panel sound insulator. See: Body and Frame/Doors, Hood and Trunk/Doors
2. Remove the front door window glass.
3. Remove the center pin from the front door window regulator attaching rivets with drift punch. Then, drill out remainder of rivet heads using a
1/4-Inch drill.
NOTE: Use care not to enlarge sheet metal holes in the door inner panel during drilling.
4. Slide equalizer arm out the end of the equalizer arm bracket.
5. Remove front door window regulator from the door.
INSTALLATION
1. Position front door window regulator in door. Align retention holes to door inner panel.
2. Install four rivets retaining front door window regulator to door inner panel using Rotunda Blind Fastener Installation Tool 107-R0600 or
