Sprinter 2500 L5-2.7L DSL Turbo (2002)
Door Switch: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
Door Jamb Switch Remove/Install
2. Open the door and remove the screw that secures the door jamb switch to the hinge pillar of the door opening.
3. Pull the door jamb switch away from the mounting hole in the pillar far enough to access and disconnect the vehicle wire harness connector from
the back of the switch.
INSTALLATION
1. Position the door jamb switch close enough to the mounting hole in the hinge pillar of the door opening to reconnect the vehicle wire harness
connector to the back of the switch.
2. Position the door jamb switch into the mounting hole in the hinge pillar.
3. Install and tighten the screw that secures the door jamb switch to the hinge pillar.
4. Reconnect the battery negative cable.