Sprinter 2500 V6-3.0L DSL Turbo (2008)
1. Position the Overhead Control Panel (OCP) housing (2) and the Roof Control Module (RCM) into the vehicle as a unit.
2. Reconnect the wire harness connection to the receptacle on the top of the RCM and to the hands-free microphone if the vehicle is so equipped.
3. Engage the two fixed retention tabs on the left side of the OCP housing above the headliner (1) through the left side of the mounting hole.
4. Slide the OCP housing toward the left side of the vehicle far enough to engage the two spring clips (3) on the right side of the housing through the
right side of the headliner mounting hole.
5. Using hand pressure, push the right side of the OCP housing up firmly and evenly into the right side of the mounting hole until the two spring clips
are fully engaged above the headliner.
6. Snap the right front dome/reading lamp lens back into the OCP housing.
7. Reconnect the battery negative cable.
