Sprinter 2500 V6-3.0L DSL Turbo (2008)
1. Position the Programmable Special Module (PSM) to the module mounting strip (3) within the driver side front seat riser (1).
2. Install and tighten the two screws that secure the PSM to the mounting strip. Tighten the screws securely.
3. Reconnect the vehicle wire harness connectors to the connector receptacles on the top of the PSM.
4. Position the module mounting strip (3) to the top of the inboard and outboard sides of the seat riser (1).
5. Install and tighten the three screws (2) that secure the module mounting strip to the seat riser. Tighten the screws securely.
6. Position the seat riser cover (1) over the seat riser (3). Gently and evenly bend the cover far enough to engage the tabs that secure the edges of the
cover to the top of the seat riser.
7. Reinstall the driver side front seat onto the top of the seat riser. .
8. Reconnect the battery negative cable.
9. Using a diagnostic scan tool, perform PSM Initialization/Configuration through the scan tool "Misc. Func.'s" menu to match the vehicle accessory
content.
