Sprinter 3500 V6-3.0L DSL Turbo (2007)
3. Place the strands of wire overlapping each other inside of the splice clip.
4. Using crimping tool, Mopar p/n 05019912AA, crimp the splice clip and wires together.
5. Solder the connection together using rosin core type solder only.
CAUTION: DO NOT USE ACID CORE SOLDER.
6. Center the heat shrink tubing over the joint and heat using a heat gun. Heat the joint until the tubing is tightly sealed and sealant comes out of both
ends of the tubing.