Sprinter 3500 V6-3.0L DSL Turbo (2007)
1. Disconnect and isolate the battery negative cable.
2. Adjust the steering wheel (1) downward to its lowest position.
3. Insert a trim stick or another suitable wide flat-bladed tool between the upper edge of the instrument cluster (2) lens and the underside of the
cluster bezel hood formation and pry the cluster gently and evenly outward until the integral latch (3) at each side of the cluster unsnaps from the
instrument panel.
4. Pull the cluster out from the instrument panel far enough to access and disconnect the wire harness connector (2) from the receptacle on the back
of the cluster rear cover (1).
5. Remove the instrument cluster from the instrument panel.
Installation
INSTALLATION
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting
any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect
and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further
diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result
in accidental airbag deployment.
1. Position the instrument cluster to the instrument panel.
2. Reconnect the wire harness connector (2) to the receptacle on the back of the cluster rear cover (1).
