Metro L3-61 1.0L (1990)
Tool Required:
J 34857 Seal Installer
1.
Speedometer driven gear into housing.
2.
Roll pin through housing. Apply GM # 1052196 lubricant to new lip seal.
3.
New lip seal into housing using a J 34857 seal installer and a hammer (Figure 2).
4.
New 0-ring seal onto housing. Apply GM # 1052196 lubricant to 0-ring seal.
5.
Speedometer driven gear housing into transaxle case. Rotata driven gear with a small screwdriver to ensure proper gear mesh.
6.
Speedometer driven gear housing retaining bolt.
Tighten
Speedometer driven gear housing retaining bolt to 6 N-m (53 lb.in.).
7.
Speedometer cable to the driven gear housing.
8.
Speedometer cable case clip. Lower speedometer cable boot over the driven gear housing.
9.
Battery negative (-) cable.
