Metro L4-079 1.3L VIN 9 TBI (1995)
4.
With push rod resting on pin latch of latch assembly, fasten push rod with joint directing opening to inside of door (Figure 8).
5.
Check play of push rod by operating outside door handle. If push rod play is not within specification, repeat Steps 3 and 4 (Figure 8).
Adjust
Push rod play 0.5 mm - 1.5 mm (0.02 - 0.06 inch).
Important:
Door lock may not operate properly if push rod play is not within specifications.
6.
Confirm that door does not open when locked and door opens when unlocked.
7.
Two screws securing rear guide channel.
8.
Push weatherstrip into lower end of door guide channel.
9.
Window. Refer to "Rear Door Windows".
10.
Water deflector. Refer to "Water Deflector".
11.
Rear door trim. Refer to "Rear Door Trim".
Power Door Lock
Remove
1.
Rear door trim. Refer to "Rear Door Trim".
2.
Water deflector. Refer to "Water Deflector".
3.
Rear window. Refer to "Rear Windows".
4.
Two screws securing rear guide channel.
5.
Unclip electrical connector.
6.
Disconnect joint of outside handle opening rod (Figures 5 and 6).
