Metro L4-079 1.3L VIN 9 TBI (1995)
Compressor Clutch Coil: Service and Repair
Remove or Disconnect
Tool Required:
J 41384-Clutch Plate Holder/Remover
1. Compressor assembly from vehicle.
2. A/C compressor clutch.
Clutch Coil Wiring Retainer And Bolt
3. Clutch coil wiring retainer from compressor housing, one screw.
4. Clutch coil from compressor.
Inspect
Tool Required:
J 39200 Digital Multimeter
^
Pressure plate for wear and scoring. Replace if necessary.
^
A/C compressor clutch pulley for wear and scoring. Replace if necessary.
Inspecting Compressor Clutch Coil Resistance
^
Clutch coil for resistance using tool J 39200. Replace if not within specification.
-
Standard resistance: 2.9 to 3.8 ohms.
Install or Connect
1. Clutch coil to compressor.
2. Clutch coil wiring retainer to compressor housing; secure with one screw.
Tighten
^
Clutch coil wiring retainer bolt to 2 to 2.5 N.m (1.4 to 1.8 lbs.ft.).