Metro L4-079 1.3L VIN 9 TBI (1995)
Fuel Pressure Release: Service and Repair
Description
FUEL PRESSURE RELIEF PROCEDURE
WARNING:
-
To reduce the risk of fire and personal injury, it is necessary to relieve the fuel system pressure before servicing the fuel system.
-
After relieving fuel system pressure, a small amount of fuel may be released when servicing fuel pipes or connections. In order to
reduce the chance of personal injury, cover fuel pipe fittings with a shop towel before disconnecting, to catch any fuel that may leak
out. Place the towel in an approved container when disconnect is completed.
-
Do Not perform this procedure if the engine is hot, for possible damage could be caused to the catalyst.
1. Loosen fuel filler cap to relieve fuel tank pressure.
2. Remove relay box cover from relay box.
3. Disconnect fuel pump relay from relay box connector.
4. Crank engine and allow to stall. Crank engine for an additional 3 seconds to assure relief of any remaining fuel pressure.
5. Remove negative (-) battery cable to avoid possible fuel discharge if an attempt is made to start the engine.
6. Reconnect fuel pump relay to relay box connector.
7. Install relay box cover to relay box.
8. Tighten fuel filler cap.
