Metro L4-079 1.3L VIN 9 TBI (1995)
Clutch Start Switch: Adjustments
1.
Disconnect battery ground cable.
2.
Disconnect electrical connector at clutch start switch.
3.
Loosen switch locknut, then back-off switch adjustment.
4.
Connect an ohmmeter between switch terminals.
5.
Position clutch pedal at approximately 0.6 to 1.2 inches from floor and hold.
6.
Rotate switch into bracket until ohmmeter just indicates continuity, then tighten locknut. Torque locknut to 10 ft lbs
7.
Connect switch electrical connector and battery ground cable.
