Prizm L4-1.8L DOHC (1994)
Antenna: Testing and Inspection
Antenna Lead-In Resistance Check
Table 1 - Lead-In Cable Resistance Values
Figure 3 - Checking Lead-In Cables
PROCEDURE
Refer to the Table and Figure above for the proper location and values for antenna lead-in resistance checks. When checking resistance, cautiously
wiggle the lead-in tip and cable. The readings in the Table should always be obtained. If not, some part of the lead-in is intermittent and should be
replaced. If all readings are as shown, try the following:
1. Run a braided ground strap to the antenna lead-in.
2. Use a noise sniffer to check for noise around lead-in. Refer to Radio, Stereo, and Compact Disc, System Diagnosis, "Noise Diagnosis
Hints."