Prizm L4-108 1.8L DOHC VIN 8 MFI (1995)
REMOVAL
1. Siphon 2/3 of the brake fluid from master cylinder, raise and support vehicle, and remove wheels.
2. Reinstall two wheel nuts to retain rotor.
3. Remove union nut securing brake hose to caliper and drain fluid into suitable container.
4. Remove clip from parking brake and disconnect parking brake cable.
5. Remove caliper mounting bolt, lift caliper, then remove parking brake pin clip.
6. While pushing parking brake crank, Fig. 6, remove pin.
7. Lift caliper and remove from vehicle.
INSTALLATION
1. Position caliper over mounting bracket, then install mounting bolt and torque to 14 ft. lbs.
2. Install parking brake clip.
3. Install brake hose and union bolt, using new copper gaskets, then torque bolt to 22 ft. lbs.
4. Refill master cylinder and bleed brake system.
5. Adjust parking brake as follows:
a. Pull upward on parking brake lever several times, then fully release lever.
b. Depress brake pedal several times to automatically adjust brake.
c. When properly adjusted, parking brake crank should just contact stopper pin.
Disassemble/Assemble
