Prizm L4-108 1.8L DOHC VIN 8 MFI (1995)
Engine Compartment Fuel Hoses
7. One bolt and fuel feed hose bracket from lower LH intake manifold (see image).
8. One bolt and fuel feed hose from fuel rail.
9. Two clamps and fuel return hose from fuel pressure regulator and pipe.
10. Two clamps and fuel return hose from fuel return pipe by EVAP canister.
11. One clamp and EVAP (vapor) hose from fuel vapor pipe.
INSTALL OR CONNECT
1. EVAP (vapor) hose to fuel vapor pipe; secure with one clamp.
2. Fuel return hose to fuel return pipe by EVAP canister; secure with two clamps.
3. Fuel return hose to fuel pressure regulator and fuel return pipe; secure with two clamps. Insert new gaskets onto fuel feed inlet-to-fuel rail
connection.
4. Fuel feed hose to fuel rail; secure with one bolt. Tighten Fuel feed hose-to-fuel rail bolt to 29 Nm (21 lb. ft.).
5. Fuel feed hose bracket to lower LH intake manifold; secure with one bolt. Tighten fuel feed hose bracket bolt to 10 Nm (89 lb. in.).
^
Insert new gaskets onto fuel feed hose-to-fuel filter bolt.
6. Fuel feed hose to top of fuel filter; secure with one bolt. Tighten fuel feed hose bolt to 29 Nm (21 lb. ft.).
7. EVAP canister to bracket; secure with one bolt. Tighten EVAP canister bracket bolt to 20 Nm (15 lb. ft.).
8. Two EVAP hoses to EVAP canister; secure with one clamp.
9. ACL cap to ACL housing; secure with four clips.
10. ACL hose to Throttle Body; secure with one clamp.
11. IAT sensor electrical connector.
12. Negative (-) battery cable. Tighten negative (-) battery cable-to-negative (-) battery terminal retainer to 15 Nm (11 lb. ft.).
AFTER REPAIR INSPECTION
Turn ignition switch to "ON" and momentarily connect a jumper between Data Link Connector (DLC) terminals "+B" and "FP" to pressurize the
fuel system. Check for any fuel leaks.
