Prizm L4-108 1.8L DOHC VIN 8 MFI (1995)
Knock Sensor: Service and Repair
Knock Sensor
KNOCK SENSOR REPLACEMENT PROCEDURE
REMOVE OR DISCONNECT
1. Negative (-) battery cable.
^
Raise and suitably support vehicle.
2. Knock Sensor (KS) wiring harness connector from KS.
3. KS from engine block.
INSTALL OR CONNECT
1. KS to engine block. Be sure threads are clean. Tighten KS to 19 Nm (14 lb. ft.).
2. KS wiring hamess connector to the KS.
^
Lower vehicle.
3. Negative (-) battery cable. Tighten negative (-) battery cable-to-negative (-) battery terminal retainer to 15 Nm (11 lb. ft.).
