Prizm L4-108 1.8L DOHC VIN 8 MFI (1995)
and 325 ohms, replace the distributor housing.
3. Air gap between the signal rotor and CMP sensor. If the air gap is not between 0.2-0.4 mm (0.008-0.016 inch), replace the distributor housing.
Inspecting Distributor Shaft
INSPECT
^
Shaft for roughness or wear. If it feels rough or worn, replace the distributor housing assembly.
^
Distributor cap and rotor for cracks, terminal corrosion and wear; replace as necessary.
INSTALL OR CONNECT
1. Noise suppressor condenser to distributor housing; secure with one screw.
2. Harness retainer to distributor housing; secure with one screw.
3. Connector to harness retainer.
4. Ignition coil to distributor housing; secure with four screws.
5. Four wires to ignition coil terminals; secure with two nuts.
NOTICE: When connecting the wires to the ignition coil, insert them properly into their grooves found on the side of the ignition coil and make
sure the wires do not come in contact with the signal rotor or distributor housing.
^
Tighten ignition coil terminal nuts to 8 Nm (71 lb. in.).
6. Ignition coil dust cover and new gasket to distributor housing.
7. Rotor to distributor housing.
