Prizm L4-108 1.8L DOHC VIN 8 MFI (1995)
INSTALLATION
Install or Connect the following:
1. Strut assembly to vehicle; secure to strut support with mounting nuts. Do not tighten fully.
2. Strut assembly to rear suspension knuckle; secure with mounting bolts and nuts
^
Tighten
-
Strut assembly to strut support mounting nuts to 39 Nm (29 ft. lbs.).
-
Strut assembly to rear suspension knuckle mounting bolts and nuts to 42 Nm (105 ft. lbs.).
3. Stabilizer shaft joint (if equipped) to strut assembly; secure with one nut.
^
Tighten the stabilizer shaft joint to strut assembly nut to 44 Nm (32 ft. lbs.).
4. Wheel speed sensor wire harness (if equipped); secure with two bolts.
^
Tighten the wheel speed sensor wire harness bolts to 5.4 Nm (48 inch lbs.).
5. Brake hose to brake hose bracket.
6. Brake hose clip to brake hose bracket.
7. Brake pipe to brake hose.
8. Tire/wheel.
9. Raise vehicle slightly to allow for removal of jack stands.
10. Remove jack stands.
11. Lower vehicle.
12. Rear seatback side cushion.
13. Rear lower seat cushion.
14. Bleed brake system.
