Prizm L4-1600cc 1.6L DOHC VIN 5 (1989)
NOTICE:
Be certain wire colors are matched before splicing wires together.
Also, the special "crimp and seal" splice sleeves should be installed using the procedure described in section 9J (page 9J-17) of the 1992 Geo
Storm Service Manual.
8.
Position wire splices so that they are staggered and wrap all three wires together with electrician's tape.
NOTICE:
Extend tape wrapping to 50 to 70 mm (2 to 2-3/4 inches) passed ends of splices.
9.
Disconnect vacuum hose to existing MAP sensor mounted on front of dash bulkhead.
10.
Remove existing MAP sensor and replace it as shown in Figure 2 with new MAP sensor and new MAP sensor bracket assembly supplied in kit.
11.
Reconnect vacuum hose removed in step 9.
12.
Connect jumper harness connector to new MAP sensor. Snap "rosebud" retainer on jumper harness into hole on MAP sensor bracket as shown in
Figure 2.
