Prizm L4-1600cc 1.6L DOHC VIN 6 (1990)
Fig. 200 Removing Trim Bezel
Fig. 201 Removing I/P Cluster
Refer to Fig. 198, when performing the following procedure.
1.
Disconnect battery ground cable.
2.
Remove two steering wheel pad retaining bolts from back of steering wheel.
3.
Remove steering wheel pad.
4.
Disconnect horn switch electrical connector.
5.
Remove steering wheel shaft nut.
6.
Using steering wheel puller tool No. 1859-03 or equivalent, remove steering wheel.
7.
Remove two hood release attaching screws lever.
8.
Remove four lower left trim panel retaining screws, Fig. 199.
9.
Disconnect speaker electrical connector, then remove A/C duct from lower A/C register, if equipped.
10.
Remove seven steering column cover retaining screws.
11.
Remove two trim bezel retaining screws, Fig. 200.
12.
Disconnect control/defogger switch electrical connector.
13.
Disconnect rear wiper/washer switch, if equipped.
14.
Disconnect two electrical connectors and cigar lighter from trim bezel.
15.
Remove trim bezel, then four cluster bezel retaining screws.
16.
Disconnect hazard flasher and dimmer switch electrical connectors.
17.
Remove four instrument cluster retaining screws, Fig. 201.
18.
Disconnect speedometer cable and remaining electrical connectors from instrument cluster.
19.
Remove instrument cluster.
20.
Remove two cup holder retaining screws, then the cup holder.
21.
Remove four radio retaining screws, then pull radio from console.
