geo Workshop Repair Guides

Geo Workshop Service and Repair Manuals

Install or Connect|Page 524 > < Install or Connect
Page 2
background image

Inspect:  Timing belt deflection. If timing belt deflection is not 5 to 6 mm (0.20 to 0.24-inch) at 20 Nm (4.4 lb. ft.), the idler pulley must be
adjusted.

5. Timing belt guide.
6. Air conditioning compressor and bracket. Refer to air conditioning.
7. Timing belt covers. Refer to Timing Belt Cover. Raise the engine.
8. Water pump pulley. Lower the engine.
9. Right engine mount through bolt.

Tighten:  Right engine through bolt to 87 Nm (64 lb. ft.). Then remove the J 28467-A universal support fixture.

10. Windshield washer reservoir.
11. Cylinder head cover with gasket. Refer to the Cylinder Head Cover.
12. Spark plugs.
13. Crankshaft pulley. Refer to the Crankshaft Pulley.
14. Air conditioning, power steering pump, and generator drive belts and adjust as applicable. Refer to air conditioning, power steering gear and

pump, and charging system.

15. Engine wiring harness to upper timing belt cover. Raise and suitably support the vehicle.
16. Two center transaxle mount-to-center crossmember nuts.
17.

Two rear transaxle mount-to-main crossmember nuts.

Tighten:  Center transaxle mount-to-center crossmember nuts to 61 Nm (45 lb.ft.). Rear transaxle mount-to-main crossmember nuts to 61 Nm (45
lb.ft.)
.

18. Two mount nuts and stud protectors.
19. Right lower stone shield.
20. Right front wheel. Lower vehicle.
21. Battery negative (-) cable.
22. Windshield washer reservoir.

Install or Connect|Page 524 > < Install or Connect