Prizm L4-1800cc 1.8L DOHC (1993)
1.
Install vinyl sheet on sensor as shown in Figure 2.
^
Be sure edge of sheet is along edge of bracket.
^
Be sure sheet is centered on sensor.
2.
Install rear center console mounting bracket and torque bolts to 10 Nm (89 lb. in).
3.
Install rear center console and fasten with 3 screws in the tray, and two screws at the front.
4.
Install tray liner.
5.
Connect negative battery cable to battery and reset all electronic devices.
6.
Perform system check for Diagnostic Trouble Codes (DTC).
7.
Install Campaign Identification Label.
Sensor Replacement & Connector Cleaning
1.
Move both front seats completely forward and recline seatback forward.
2.
Remove rear seat cushion.
