Prizm L4-1800cc 1.8L DOHC (1993)
3.
Remove center (B) pillar lower garnish.
4.
Unclip rear door sill plates securing carpet (do not remove).
5.
Remove rear floor mates.
6.
Pull up floor carpet to allow access to 3 center sensor attachment bolts.
7.
Disconnect connectors and remove center sensor.
NOTICE:
Center sensor connectors must be cleaned prior to installation of a new center sensor. DO NOT brush or use anything abrasive on gold terminals.
8.
Fill shallow container with a small amount of Ethanol or Acetone.
9.
Dip connector in fluid to completely cover contacts and REMOVE ALL TRACES OF LIQUID RESIDUE.
10.
Blow dry connector with air.
11.
Install NEW center sensor (with protective vinyl sheet factory installed and torque attachment bolts to 21 Nm (16 lb. ft.).
12.
Reconnect center sensor connector.
13.
Install floor carpet.
14.
Secure rear door sill plate.
15.
Install rear seat cushion.
16.
Install rear floor mats.
17.
Install center pillar lower garnish.
18.
Return front seats back to up right position.
19.
Install rear center console mounting bracket and torque bolts to 10 Nm (89 lb. in.).
20.
Connect negative battery cable to battery.
21.
Perform warning light check.
22.
Perform system check for Diagnostic Trouble Codes (DTC).
23.
Install rear center console and fasten with 3 screws in the try, and two screws at the front.
24.
Install try liner.
25.
Reset all Electronic devises as noted in Step 1.
26.
Install Campaign Identification Label.
Campaign ID Label & Claim Information
CAMPAIGN IDENTIFICATION LABEL
Each vehicle corrected in accordance with the instructions outlined in this Product Campaign Bulletin will require a "Campaign Identification Label".
Each label provides a space to include the campaign number and the five (5) digit dealer code of the dealer performing the campaign service. This
information may be inserted with a typewriter or a ball point pen.
Each "Campaign Identification Label" is to be located on the radiator core support in an area which will be visible when the vehicle is brought in for
periodic servicing by the owner. When installing the new Campaign Identification Label, be sure to install the clear protective covering.
Additional Campaign Identification Label can be obtained from VISPAC Incorporated by calling 1-800-269-5100 (Monday-Friday, 8:00 a.m. to 4:30
p.m. EST). Ask for Item Number S-1015 when ordering.
Apply "Campaign Identification Label" only on a clean, dry surface.
