Prizm L4-1800cc 1.8L DOHC (1993)
Inspecting The Distributor Shaft
1.
Shaft for roughness or wear. If it feels rough or worn, replace the distributor housing assembly.
2.
Distributor cap and rotor for cracks, terminal corrosion and wear; replace as necessary.
REASSEMBLY
Install or Connect
1.
Noise suppressor condenser to distributor housing; secure with one screw.
2.
Distributor wire to distributor housing.
3.
Harness retainer to distributor housing; secure with one screw.
4.
Two connectors to harness retainer.
5.
Igniter to distributor housing; secure with two screws.
6.
Three wires to igniter terminals; secure with three screws.
7.
Ignition coil to distributor housing; secure with four screws.
8.
Four wires to ignition coil terminals; secure with two nuts.
NOTICE: When connecting the wires to the ignition coil, insert them properly into their grooves found on the side of the ignition coil and make sure the
wires do not come in contact with the signal rotor or distributor housing.
Tighten
^
Ignition coil terminal nuts to 8 Nm (71 lb.in.).
9.
Ignition coil dust cover and new gasket to distributor housing.
10.
Rotor to distributor housing.
