Prizm L4-1800cc 1.8L DOHC (1993)
Transmission Position Switch/Sensor: Adjustments
1.
Disconnect battery ground cable, then place shifter in Neutral position.
2.
Raise and support vehicle.
3.
Remove six splash shield bolts and splash shield.
4.
Remove one nut, one lock washer and shift select cable from manual lever.
Park/Neutral Position Switch
5.
Disconnect PNP electrical connector.
Manual Shaft Nut And Lock Plate
6.
Remove one nut, one lock washer and manual lever from manual shaft. Unstake lock plate behind manual shaft nut
7.
Remove manual shaft nut and lock plate from PNP switch then PNP switch bolts and switch.
8.
Reverse procedure to install noting the following:
a. Tighten manual shaft nut to 61 inch lbs.
